Electrical equipment repairs

We disassembled starter motor for defect detection and repair.

We had to reconstruct worn out working surface of the starter motor rotor.

We had to replace bearings and seals of the freewheeling clutch.

We disassembled generator for defect detection and repair.

We had to restore damaged insulation of the stator coils.

We disassembled for repair windscreen wiper drive.

Gearboxes were full of aged grease.

Wiper shafts were stuck because of corrosion products and dirt.

We prepared restored windscreen wiper mechanisms for installation.

We disassembled ventilation system fans for restoration.

All mechanical parts we cleaned and galvanized.

For maintenance, we disassembled all fan motors.

We prepared restored ventilation system fans for installation.

We disassembled horns for maintenance and repair.

Internal structure of the horns was in repairable condition.

We prepared restored horns for installation.

For maintenance and repair we completely disassembled air conditioner unit.

We completely disassembled fan motor of the air conditioner for maintenance.

Using restored housing, we assembled blower unit.

For maintenance and repair we completely disassembled radiator of the air conditioner.

We finished assembling of the horn units using restored parts.

We disassembled fuel valve for repair.

Restored parts were used for assembling of the fuel valve.

Because of damaged gasket, inner cavity of the oil level sender was filled with emulsion.

Assembling oil lever sender we used new gasket.

We completely disassembled fuel level sender for restoration.

We used restored parts for assembling of the fuel level sender.

For repair we disassembled relays.

We used restored parts for assembling of the switches.

We prepared for installation pressure senders.

For maintenance we disassembled radio unit.

On the inner wall of the housing there was still present sticker with guidance concerning sales price of the unit.

We used new and restored parts assembling dynamo.  

We completely disassembled voltage regulator and fuse box for maintenance and repair.

We prepared restored electrical appliances for tests and installation.

We received for installation all new wiring harness.

We completely disassembled speedometer for repair and replacing of the broken parts.

We tested all features of the speedometer gauge after restoration.

For repair and maintenance, we disassembled all switches and sent chromed items for re-plating.

We completely disassembled all external lighting devices for repair and re-plating of the damaged components.

We self-manufactured missing red indicator.We self-manufactured missing red indicator.

We self-manufactured missing attachment and installed new mercury switch.

Completing restoration, as broken insulator was glued and damaged cable replaced, we polished decorative parts of the aerial.

We assembled rear lamps using reconditioned components.

We bought and reconditioned period correct radio for the vehicle.