Braking system repair

Cooling ribs of front drums were broken.

We dismantled front braking mechanisms.

One of braking shoes was broken.

Braking cylinders were filled with unknown substance.

We found traces of corrosion on inner surfaces of the braking cylinders.

We found traces of corrosion on surfaces of the braking pistons.

Cooling ribs of front drums were also broken.

Rear braking shoes were in working condition.

We removed hand brake actuation mechanism.

We dismantled rear braking cylinders with hand brake actuation mechanisms.

Hand brake actuation mechanisms were clogged by mud residuals.

We found traces of corrosion on inner surfaces of the braking cylinders.

We found traces of corrosion on surfaces of the rear braking pistons.

Several brake linings were incorrectly sized.

Several rivets on certain brake shoes were missing.

We removed incorrect brake pads and riveted –on correct replacement.

We disassembled braking master cylinder block for defect detection and repair.

Needle bearings of the braking mechanism were in working state.

We had to repair mechanical components of the braking linkage.

For detailed inspection and repair we completely disassembled braking fluid reservoirs.

All rubber components were damaged and required replacement.

After cleaning all usable components were sent to powder-coating.

For detailed inspection and repair we completely disassembled handle of the emergency brakes.

All bushings of the emergency braking mechanism were worn out and we ordered replacement parts.

For detailed inspection and repair we completely disassembled mechanism of the emergency braking system.

For detailed inspection and repair we completely disassembled braking master cylinders.

Required parts of the master cylinders were noted on the list.

After cleaning, we tested suitability of the master cylinder housings for further use.

Current batch of the fittings and other components we sent to galvanizing workshop.

We assembled restored mechanism of the braking master cylinders.

We prepared for installation restored braking shoes.

We assembled restored rear braking mechanisms.

We assembled restored rear braking cylinders.

We used new and restored parts assembling front braking mechanisms.

We prepared for installation front braking mechanisms.

We disassembled braking system pipelines for restoration.

Several of braking pipes had mechanical damages and we decided completely replace braking piping.

Cleaned braking system fittings were delivered to galvanizing workshop.

We assembled braking master cylinder unit using new and restored components.

We assembled units of the braking fluid vessels using new and restored components.

We installed restored braking mechanisms onto the rear axle.

We finished restoration of the rear braking system installing braking drums onto the axle.