Ferrari 365 GTC/4 by Pininfarina

Car producer : 

Ferrari

Model:

365 GTC/4 by Pininfarina

Year:

1971-1972

Type:

Coupe



The Ferrari 365 GTC/4 is a 2+2 grand tourer produced by Ferrari from 1971 to 1972. It was based on the chassis of the Ferrari 365 GTB/4 "Daytona". In the very short two-year production run 505 examples of the GTC/4 were produced. Its chassis and drivetrain, however, were carried over mostly inaltered (apart from a wheelbase stretch to provide more satisfying rear seat room) on its successor, the 1972 365 GT4 2+2.

A short-lived interim model that bridged the gap between production of the 365GT 2+2 and 365GT4 2+2, the 365GTC/4 was first shown at the Geneva Motor Show in 1971. A contemporary of the awe-inspiring Daytona, the 365GTC/4 used a similar chassis and a wet-sump version of the former's 4,390cc four-cam V12 in a slightly lower - 320bhp - state of tune, which was coupled to a conventional five-speed gearbox rather than the Daytona's transaxle. Cylinder heads revised to accommodate side-draught carburettors enabled stylist Pininfarina to achieve an elegant, low profile bonnet line. 'In all, a graceful, clean and understated design with subtleties one discovers only by looking it over carefully. One might say this model is a Ferrari for the mature enthusiast,' observed R&T.

Altogether more civilised and easy to drive than the heavy Daytona, the rapid 365GTC/4 came with ZF power steering and servo-assisted brakes as standard, the option of air conditioning, and an especially luxurious interior featuring individual reclining front seats and occasional rear seats. In spite of the increasing emphasis on refinement, the 365GTC/4 gave nothing away to its rivals in the performance stakes, racing through the standing quarter mile in under 16 seconds on its way to a top speed in excess of 150mph. 

Sold for: 561000 USD
Go to restoration
See other models

You may also like these cars

to top